Question Latitude 0 after syncing with SkySafari

Hi,

I'm using an M-Zero mount with the latest StarGo version. To get started I typically use SkySafari Plus 5.4.0.0 and align to a star close to the meridian at the southern horizon.
In SkySafari I enabled 'Set Time&Location' in the scope setup. I also have the very same fixed(!) coordinates stored in StarGo as the mount's location and they are also fixed in SkySafari, so they never change.

After the sync, however, the Latitude is most of the time 0, while the longitude is fine. I then connect with NINA, which complains about it and offers to update the location. After this update it is fine, but I would like to avoid that.

Any idea where this could be coming from?

Best regards,
Stephan